Hose connector for 32 mm and 38 mm pool hose

Hose connector for pool hoses .

specifically for pool hoses with 32mm or 38mm diameter (e.g. Intex, Bestway).

Print profile 1: Connector for 32mm hose

Print profile 2: Connector for 38mm hose

Print profile 3: Connector from 38mm to 32mm hose

This pool hose adapter set was designed with a tight fit. The design allows for reliable sealing simply by pushing the parts together (press-fit), which makes everyday handling extremely easy.

Since water pressure can vary depending on pump performance and hose length, I recommend using a standard hose clamp in addition for higher pressure or continuous operation. Better safe than sorry!

Definitely print with PETG or even better with ASA. 

These materials are waterproof and chemical-resistant to chlorine. ASA is also completely UV-stable and will not become brittle in the sun.

Do not use PLA!

Assemble and secure with a hose clamp.

Important Safety Instructions (Please read!)

• No high-pressure systems: This adapter is designed exclusively for pressureless applications or low-pressure systems (standard pool pumps for above-ground pools). It is not suitable for domestic water pipes or high-pressure cleaners!
• Regular inspection: Since 3D prints can degrade over time due to UV radiation and chlorine, a regular visual inspection of the components is mandatory. Look for cracks, discolorations, or leaks.
• Disclaimer: This is a private project. Use is at your own risk. I assume no warranty or liability for damages (especially water damage) resulting from the use, failure of the component, or faulty printing.