Miniature Banker's Barrister's Office Chair

A miniature, banker's or barrister's office chair for your diorama or dollhouse.

The supports broke under the front left leg with only 30 minutes to go.  So I paused the print and cobbled together supports using masking tape.  In the end, that front leg was a little diminished - so I used some putty.  I was enjoying the putty so much, I went a little crazy filling in some of the grain lines Meshy added.  Hence the grey stuff.

The little rungs are very fragile.  Be careful.

Second Print Profile:

I printed it again using strong tree supports (print profile 2nd one above).  There was certainly no breakage of supports, but the clean-up was quite tedious.  If you have the patience, this one is a sure thing.  (rungs are still fragile)

All of my models are roughly 1:12 scale.  Feel free to re-scale, but with thin models, smaller may not work well.

I use stl generators, because my cad skills are very limited (and improving).  I publish the good ones here, the ones I actually make and use myself.  

(AI comes up with some crap, yes - and I scrap those)

I've found lots of great files here and want to contribute.   Hope someone can use them.  

Thanks for looking.