Luffy – One Piece Edition

🧩

Luffy – One Piece Edition

Immerse yourself in the legendary intensity of One Piece with this unique portrait of Luffy, captain of the Straw Hat crew

Every detail has been crafted to capture all the power and rage of the character in an impressive 3D print

This model highlights contrasts and volumes for a striking visual effect, perfectly suited for Hueforge technology

To support my work, you can send me a PayPal donation of any amount you wish (even 1 or 2 € or $ is appreciated) via this link: https://paypal.me/samgamji00

🔥

Highlights

• Ultra-precise facial details (gaze, scars, expression)
• Exceptional depth effect thanks to Hueforge mapping
• Optimized contrasts for a sharp and clean rendering
• Design specifically conceived for multicolor printing

🎨

Recommended Configuration

• Number of colors used: 6

  Black

  Red

  Orange

  Yellow

  Oak or Beige

  White

   

  For those without an AMS

  - Black to start

  - Pause at the 13th layer at 3:16 to put in red
  - Then 14th layer at 3:40 min to put in orange
  - 15th layer at 4:01 min to put black back in
  - 16th layer at 4:23 min to put orange back in
  - 17th layer at 4:38 min for yellow
  - 19th layer at 5:08 min to put in oak or beige

  - 27th layer at 6:02 for white

   

   

         For those with an AMS

You will need to make a change in your AMS but it's nothing complicated, I'll explain

You start by putting black in your AMS slot 1, red in 2, orange in 3, and yellow in 4

Set an alarm for around 4:23 and wait for it to print orange again. As soon as it switches to orange (2nd time), remove black and red from the AMS and replace them with oak or beige in black's place, and white in red's place

Then just let it print until the end

It sounds complicated, but in reality, it's very simple

⚙️ Recommended Print Settings

• Layer height: 0.08 mm (top quality)
• Total thickness: ~2 to 2.4 mm
• Good calibration recommended

🧠

Tips

For optimal results:

• Use quality filament (Bambu / Sunlu / eSun)

   

• I had a small issue with the eye on the left when looking at it; it's not white. To remedy this, I simply added a dab of white marker as you can see in the last photo. It takes 5 seconds and looks better.

💥

Why this model is special

This Hueforge is more than just an image:

it's an artistic piece that brings one of One Piece's most iconic characters to life with a stunning embossed effect once printed

🙌

Support

If you like the model:

• Leave a like 👍
• Share your print 📸
• A boost would be appreciated
• Follow me for more Hueforge creations 🔥