Fiat 500 USB Lamp

Fiat 500 lamp with LEDs and USB connection

In the file there are 5 plates, the car can also be printed with separate colors, I printed with 0.4 PLA 2 colors

The base can be customized with whatever you want on the front inscription

FOR THE HEADLIGHTS

Recommended settings (Transparent PLA)

Layer height:

• 0.12 mm (ideal)
• or 0.08 mm if you want a top lens effect

Walls:

• 3

Infill:

• 100%

Speed:

• 20–25 mm/s

nozzle temperature:

• 210°C

Bed:

• 60°C

Fan:

• 40–50%

Supports:
❌ OFF

Orientation:
👉 flat base on the bed

this is to best print the headlights

the car fits perfectly on the base without needing glue, although a little is recommended

I am available for anything, I am preparing a series of iconic cars and soon the Vespa 50 special

12 volt LEDs with LED holders taken from Amazon, specifically 5 mm 12 V ones

YIXISI 50 Pieces 5mm Diode ad... https://www.amazon.it/dp/B08N9LLZ82?ref=ppx_pop_mob_ap_share

a switch also bought on Amazon

RUNCCI-YUN 6Pcs Connector... https://www.amazon.it/dp/B0CWNQB19C?ref=ppx_pop_mob_ap_share

and finally a USB cable

RUNCCI-YUN 6Pcs Connector... https://www.amazon.it/dp/B0CWNQB19C?ref=ppx_pop_mob_ap_share