Valorant Rune Dagger (all parts separated, no multi-color needed)

1.1 Valorant Holy Stone Dagger filament recommendations are as follows:

1. Weapon gem part (light blue part) Recommended filament: PLA Transparent (Blue) or Transparent with Glitter (Blue) Filament used in diagram: Yuxiongdi PLA Glow

2. Weapon handle black part Recommended filament: Official PLA Black or TPU Black Filament used in diagram: Official PLA Black 10101

3. Gold-brown part in diagram Recommended filament: Cai Duowu PLA Silk Gold Silver Copper Tri-color Blend Filament used in diagram: Cai Duowu PLA Silk Gold Silver Copper Tri-color Blend

4. Silver part in diagram Recommended filament: Official PLA Silk Silver 13109 Filament used in diagram: Official PLA Silk Silver 13109

2.1 Assembly steps are as follows:

1. Combine the three parts shown in the diagram (If the joints are too loose during assembly, super glue is recommended)

2. Combine the four parts shown in the diagram (If the joints are too loose during assembly, super glue is recommended)

3. Combine the two parts shown in the diagram (It is not recommended to use super glue when combining this part, as its position may need to be adjusted later)

3.1 For those making models using a non-cold build plate, please note (Those using a cold build plate can skip this step)

The initial model has better adhesion to the build plate, so the bottom right corner is not removed as shown in the figure below. You will need to use pliers to cut off the marked part. Just trimming a small bit will not affect the model

3.2 Assemble the model

4. Join the assembled parts (It is recommended to follow the steps below)

4.1 If too loose during joining, super glue is recommended

4.2 After inserting the model, it is recommended to secure it with super glue

This work is for personal use and non-commercial sharing on MakerWorld only. Copyright belongs to the official Valorant game. Please do not use it for commercial purposes without permission (including paid printing services on Xianyu)