Search models, users, collections, and posts
dji rc n3 phone tilt bracket
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
26 min
1 plate
Open in Bambu Studio
Boost
13
32
12
0
56
30
Released
Description
Updated version!!
slightly shorter in the front/top of the phone, now it doesn't cover the top of the screen as much.
Changed the original file for the new one. So just one profile.
Slightly shorter version than the original. ( for strength with PLA )
100% infill, prints with pla.
i use this just so my buttons on my phone wont get pressed when i attach my phone.
and i have a card holder on the back of my phone.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (12)