Medieval Sentinel 55mm Miniature Multipart & Full

Hey everyone!

This is a 55mm Medieval Sentinel miniature, designed with a lot of detail for those who enjoy high-quality prints.
You can print it in two ways:

• Multipart version (easier for cleaner details and better results)
• Full model version (for convenience)

⚠️ Before you print (important!)

This is not a beginner-friendly model if your printer or filament isn’t well calibrated.

To get a good result, make sure:

• Your printer is properly calibrated
• Your filament is tuned (temperature, flow, etc.)
• Your supports are dialed in

If not, you’ll likely run into issues like poor detail, failed supports, or rough surfaces.

⚙️ Settings I used (as a reference)

• Layer height: 0.12 mm
• Speed: Reduced (slow printing for better detail)
• Infill: 100%
• Supports: Carefully tuned (very important for this model)

These settings worked well for me, but feel free to tweak based on your setup.

🔥 Final note to the community

I’d really love to see how this prints on different machines!

If you try it:

• Experiment with your own settings
• Push for the best quality you can get
• And share your results here 👇

Let’s figure out the best setup together 💪