Rugged Insulin / Peptide Case for 3x 10ml Bottles

Based on a parametric rugged case design - the insert and gasket were designed from scratch to fit 3 10ml insulin bottles.  The gasket prints upside down and may need to be started and then closed into the body to get seated (gasket isn't a required part if this is too annoying).   Uses 3 3x30mm screws for the hinge and latch.   I printed the insert in Sunlu 90a TPU to hold the bottles but give them a little cushion,  test printed in PLA and they still fit perfectly.  Printed walls outer then inner to keep tolerances clean.  

*****NOTE***** This is designed for the shorter (45mm tall) 10ml bottles - apparently there are two sizes.  I do not have any of the taller bottles to measure / test with - if someone with one can tell me how far the top of the vial sticks up and out of the case I can add some depth to allow them to fit!