Zenless Zone Zero Kargocar 1:1 Replica Super Large

It's finally open source, which is the best outcome for this model

The uploaded version is circuit-free, which reduces the printing difficulty

The print profile has been debugged, and the load-bearing capacity exceeds expectations It can carry over 90kg

For real-world effects, you can check Douyin: 五二五+, Bilibili: 五二五十 There are actual video demonstrations

Since the model is too large, putting it in one print profile would cause issues and make it hard to find, so the print profiles will be separated Please refer to the profile names

The main accessories are as follows

Additionally, since the pull rod you buy might not be the same model, no holes are pre-drilled You will need to use a hand drill with an M6 drill bit to make the holes

Hinge screws should be short, within 3*10mm, preferably 3*6mm

I will make a video about the installation steps You can search on Douyin: 五二五+, or 卡格车安装步骤 (actually it's just gluing and screwing, not watching it isn't too hard for installation)

The sound and light circuit board is also free and open source, but it's a bit complex and requires more tools, so I won't upload it to the platform You can message me for the files, and I'll give you the files and the list of necessary accessories

If you can't find the accessories, you can also message me, and I'll help you find them

Please note, as the model is large and printing takes a long time, please assess your acceptance of the printing time and filament costs in advance I wish you success