EarthSet Hueforge 200x200 (From Artemis II)

I've been loving everything to do with NASA's Artemis 2 mission around the moon, and was so excited to see new photos. When i saw this new Earthrise photo, I knew I had to make it into a Hueforge, and it came out great. 

This is a thinner hueforge, so don't make the same mistake I made and make sure you print this on a textured PEI plate, not a supertak plate, and let it cool down before trying to remove it.

This uses 5 colors. Easy to do with an AMS, simply assign the 5th color to slot 1, and mid-print, after color 1 is finished, swap out color 1 for color 5, and you're good to go.

I have a frame here that I'm using for mine: 

https://makerworld.com/en/models/1467994-hueforge-200x200-frame-fast-print-19g-43min#profileId-1531660

Project: art002e009285~orig-square.JPG

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2mm

    #080a0d PLA PolyLite Black  Transmission Distance: 0.3
    #4c5f71 PLA BambuLab Basic Blue Gray  Transmission Distance: 3
    #d1d3d5 PLA BambuLab Basic Light Gray  Transmission Distance: 1.7
    #0078bf PLA BambuLab Matte Marine Blue  Transmission Distance: 0.5
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5

This print uses 5 unique filaments

Swap Instructions:
    Start with Black
    At layer #7 (0.64mm) swap to Blue Gray
    At layer #10 (0.88mm) swap to Light Gray
    At layer #13 (1.12mm) swap to Marine Blue
    At layer #20 (1.68mm) swap to Jade White for the rest.