Super Mario Galaxy McDonald's Toy Stand

Disclaimer / License

This model is for personal use only.
Commercial use is not allowed.

You may not sell, redistribute, or use this model or any printed versions of it for profit without my explicit permission.
If you are interested in selling the printed version of this model you will have to purchase my Commercial License on Patreon: 
https://www.patreon.com/Fabria3D/membership ($10 membership gives you the right to sell all past, current or future models on my MW page while valid)

Super Mario Galaxy x Mcdonalds Toy Stand

Details:

The print uses around ~500 grams of filament. It takes around 14 hours to print on a single printer. You can print multiple of the same background or shelf to minimize this time.

Assembly:

In the picture below you have the base stand, which has 3 connectors on it, you slide each of the shelves onto these connectors. Each shelf coresponds to a specific connector. The Cloud shelf goes on top, and it's connector is slimmer than the other two. The white castle bricks go on the bottom, the brown bricks go in the middle, and the cloud goes on top.

After connecting every shelf, you grab each background and fit it into it's spot as the background for each level.

Test fit everything together, and finally add a bit of glue to everything so it holds! That's it. :)
 

Filaments used:

• Bambu Lab PLA Basic Cyan
• Bambu Lab PLA Basic White
• Bambu Lab PLA Basic Black
• Bambu Lab PLA Basic Red
• Bambu Lab PLA Basic Sunflower Yellow
• Bambu Lab PLA Basic Bambu Green