Search models, users, collections, and posts
Wall key holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.1 h
1 plate
Open in Bambu Studio
Boost
4
18
0
0
11
3
Released
Description
Wall key holder, 18cm long.
The key holder is mounted using a fixation part to drill on the wall (a drill guide is available to mark holes correctly). After the fixation is fixed, just slide the key holder and that's it !
That key holder is strong enough to be printed using PLA, PETG is not mandatory.
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
Comment & Rating (0)