IKEA SKÅDIS Desk Stand – Top Support Tray

IKEA SKÅDIS Desk Stand – Top Support Tray (Screwless Wall Mount)

If you’re using your IKEA SKÅDIS pegboard on a desk with standalone feet, you might notice it gradually leaning forward as you add more weight.

This model is designed to fix exactly that.

🧩 How it works

• The support sits on top of the SKÅDIS board
• The distance from the wall to the back of the SKÅDIS board measures 36.5 mm
• It keeps the same distance from the wall as the bottom feet, preventing forward tilt
• The back is sized for 20mm double-sided tape for a clean and simple installation
• The extended top doubles as a handy tray for small accessories
• Add one of these on top in the middle of the board, or 1 on each corner.
  U can add as many as you want.

🔗 Perfect combo (Recommended)

This model is designed to be used together with the SKÅDIS desk feet by MaxX_Power:

👉 https://makerworld.com/en/models/59302-skadis_stand_for_table#profileId-61348

Huge thanks to MaxX_Power for the original bottom stand design 🙌
Combined with these feet, this top support creates  a stable SKÅDIS setup.

🛠️ Printing

• Material: PETG (but PLA should work just fine)
• Walls: 4
• Infill: 20% gyroid
• Layer height: 0.2mm
• No supports needed
• Print orientation: topside flat on the bed
• Clean the bed or add a brim if you have adhesion troubles
• This was printed on my A1 without any problems.

💡 Notes

• For heavier setups, use strong double-sided tape or mounting strips
• Designed for standard SKÅDIS thickness
  
  If you want me to adjust the size or add screwholes, just send me a message.
  I wil do my best do adjust the desing to your needs.