Search models, users, collections, and posts
Modular filament spool shelf
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 6% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
64
209
6
5
73
34
Released
Description
This is a very minimal bracket to aid in building a standalone storage system for your filament spools
- each bracket uses just 77g of filament
- fits on A1 and p1s models (256x256mm build plates)
- uses 7/8 inch wooden dowels found at most home improvement stored for around $5
- if only one shelf is needed (not multiple levels) you can use just three dowels and skip the 4th
- for every level of shelf after the first, two dowels and two brackets are needed
- fits refill filament and full spools
- consider a bracket to bridge the space of the dowels if extra support is needed in the middle
will consider adding different diameter holes but unable to go over 7/8 inch otherwise print will not fit on 256x256mm buildplate
any comments or suggestions are welcome
thanks!
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (6)