Easier Print Pony Beads

About

This is a standard pony bead at 6x9mm.  It has some slight adjustments to make for easier printing, specifically more surface area on the bottom.  This allows the first layer to print with three loops, instead of just two, like with other versions.

Print Instructions

No supports needed.  If bed adhesion issues occur, recommend trying to use a glue stick.  I had success testing with an inner brim, but it may be tedious to remove them.

More Beads

https://makerworld.com/en/models/2676000-assorted-beads

Connect with Me

I'm excited to share my 3D designs with the community, and I'd love to see your prints!  If you share them on Instagram, please consider tagging me, so I can celebrate your amazing prints!

Instagram: @OriginalClassicAdam

YouTube: @OriginalClassicAdam

Friendly Reminder and Disclaimer

These models are provided as-is, so please take care when using them and adapt as needed. Please use common sense and caution when printing or assembling.  I cannot make any guarantees about their performance or safety.  By downloading or using these files, you accept responsibility for any outcomes.