Search models, users, collections, and posts
Eufy Camera mount for P1S P2S X1C X2D
Remixed by
IP Report
Print Profile(1)
PETG 0.16mm layer, 4 walls, 15% infill
Designer
3.1 h
1 plate
Open in Bambu Studio
Boost
15
86
4
1
13
16
Released
Bill of Materials
Bambu Filaments
Select all
Description
V2 Released (May 15, 26) - Rotated the mount for better printability and better support locations.
This is a remix of the blink camera mount.
Since it is only hung in the door, it can be used on both the P1S, P2S, X2D and the X1C and aligned as desired on the edge.
The mount should be printed in PETG with a layer height of 0.16 and 4 walls.
The camera in it right now is the Eufu Indoor 2k camera.
I would recommend a rubber or foam piece of padding near the bottom, so it sits nicely on the glass.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)