SCX30 Range Rover Truck Body

For more detail, use .2 nozzle. (4x) M1.4x4 screws used to attach Bed to Cab and (2x) to attach Grille to body (with some glue along top if needed. Place wood bed in from bottom, then run a small bead of E600 or similar adhesive along the seam from underneath. Hood vent is glued in from bottom, slats up, like on the print bed.

Picture is on a stock wheelbase SCX30, may need to cut off the rear hook of battery strap retainer to have body far enough forward. Should work for +5mm without modification. Holes in grille are 6mm diameter for lights (6mm LED Panel lights work great).