Bambu Lab Plate Labeling PLA / PETG

Here is the print for the H-models (H2C, H2S, H2D):

H-models

Have you also had problems with print bed adhesion?

Often it's because you print PLA and PETG on the same plate. These materials repel each other.

Therefore, you should use one side only for PLA and the other side only for PETG.

You can label which side is for which filament with my holder.

The labels should fit all Bambu Lab plates that cover a build volume of 256 x 256 x 256. For example, those from the P2S, X2D, P1S etc

The holders are designed to accommodate a 5mm x 1mm round magnet. This holds the two halves together on the print bed. However, if you only have weak magnets or none at all, you can simply connect the halves with a drop of glue.

Please pay attention to the orientation of the two halves! They cannot be installed mirrored. The side with the small recess goes up. So towards the center of the print plate. See the pictures for this.