Search models, users, collections, and posts
Print Profile(1)
0.16mm layer, 2 walls, 100% infill
Designer
23 min
1 plate
Open in Bambu Studio
Boost
5
19
1
0
13
9
Released
Description
Classic SMA Connectors
Snap on & screw off!
I present to you, the ones we all know and love! These take literally a minute to print each, which just makes printing batches extremely convenient. I want to cut time down as much as possible, because time is money!
Standard PLA will do, I just chose yellow to fit the OG aesthetic.. But always remember to either use the print profile or follow my instructions! Otherwise they may not fit, I have printed these over one hundred times, to get the perfect fit.
0.16mm is required, otherwise the seam is too large and it doesn't fit properly. And slowwww the print down a bit, not much. Just not standard, 50% your usual is perfect. Otherwise the seams don't form properly and also ruin the fit completely.
If you've followed all the instructions and they still dont fit, please check your printer. I have done everything I can to ensure they are a snug tight fit. Scaling the X + Y by 0.1mm + or - depending on the fit, is usually enough. However they should be fine.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)