Search models, users, collections, and posts
Unsinkable Boat!
IP Report
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
12 min
1 plate
Open in Bambu Studio
Boost
2
5
2
0
8
7
Released
Description
The Unsinkable Boat!
This is model of a unsinkable boat I made! This model takes less than 15 minutes to print, and only costs 2.76g of filament! I tested this out in my hot tub and this thing could not sink even if I tried as hard as I could! Sadly it can tip over, but there is no way to stop that, but, it still floats above the water :D! I hope you enjoy the model!
Boost Me (for free)
Like my models? Why not help me out :D
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (2)