Industrial phone stand

A remix of the Industrial Phone stand by Josh-3D that has TPU feet so it doesn't slide on your desk. You can find instructions below. (For the TPU feet you just put them under plastic feet).

[Tools & Assembly]

the cell phone stand is pretty easy. You'll need the following hardware and tools.

I designed this to use M3 socket cap screws.

Hardware Needed:

(Full disclosure, I am part of the Amazon Affiliate Program. All amazon links are affiliate links. I earn a small commission from these links without any added cost to you. These links help to support me so I can bring more content for free!

I use screws from Bambu's Makersupply, and mainly design around those. However, you can purchase self tapping screws from amazon if that's easier for you. I'd recommend an assortment like this Amazon US, or Amazon US.)

• M3x12 - 4 (used for the feet)
• M3x25 - 3 (Used to connect the swing arm to the stand, and the phone holder to the swing arm)
• M3x30 - 1 (Used for the knob for the swing arm)
• M3xNuts x 9 (The knob makes use of two nuts!)

Tools Needed:

• Hex Driver
• Drill bit for clearing holes

Start by drilling out the holes in the feet and knob. These holes were partially blocked to get a cleaner print. All the other holes should be sized that a M3 screw can fit through without being too tight, but things like variation in filament properties might make the holes tight, so if you can't freely push a screw through the holes in the frame, clear them out with an appropriately sized drill too.

Next, Prepare the knob! We'll feed a M3x30 screw through the hole and through a nut that'll be embedded on the other side of the knob. Tighten it down!

Now we'll assemble the main frame! There's embedded slots for all of the M3 nuts, so go ahead and prepare by putting all the nuts in place. Next, we'll install the feet, as once the holder and swing arm are on, it can obstruct access to the screws for the front feet. Use M3x12 screws for the feet! For the swing arm, attach the two phone holder sides using M3x25 screws. Attach the arm to the base using a M3x25mm screw, but make sure not to over tighten it as we don't want the hing to be too stiff! Lastly, install the knob through the guide and swing arm and tighten it down!