X120 Halberd Tail-sitter VTOL Fixed-wing

Tail-pusher VTOL flying wing

Wingspan 120 cm

Fuselage uses PETG, wings use PLA Aero, and a small amount of TPU

Carbon rods:

10mm carbon tube, 1 meter long, 1 piece

 3mm carbon rods: 15cm*2, 10cm *2, 5cm*8

 For 2mm, just buy one meter and cut it, they are all for positioning

Hardware:

As usual, buy a bunch of M3 and M2 heat-set inserts, about twenty should be enough, with lengths of 3 to 4. Also buy a bunch of M2 and M3 screws. M2 screw lengths are 6, 10, 15. M3 screw lengths are 6, 8, 15. I think most hardware stores sell them in packs of twenty or thirty, which should definitely be enough.

Electronics:

F405 flight controller, just make sure it has more than 7 PWM outputs

Two PTK7465 servos

Three PTK7452 servos (any brand like YinYan is fine as long as the size is the same)

Two motors sized between 2306 and 2810 that can use 6 to 8-inch propellers. I use TMOTOR F60PRO 2000KV with 6045 propellers.

I use a 4S 1500mAh battery, a 4S1P 21700 might also work.

Two separate AM32 50A ESCs