Easter decorative light (for Bambu Lab Candle Lamp Module)

Fully disassembled design, separate printing, customizable colors

For printing filament, choose a light skin tone [corresponding to Bambu Lab Apricot (PLA), Pink (PLA), Orange (PLA). Orange is recommended to be replaced with warm white or khaki. Filaments with lower transparency are recommended.

All three colors of Bambu Lab candle lamps are compatible

Warm white is recommended for more uniform color

The translucent parts are all installed with snap-fits. The printed small round pieces can be directly pressed in. Due to different material compression rates, if too tight, it might be due to overhangs causing an irregular circle; clean it or trim the edges of the round piece. If too loose, glue can be used for installation. The same applies to the bunny ears.

The red arrow in plate three points to an auxiliary lampshade. Due to varying light transmission properties of different materials, the candle lamp may appear too bright, and excessive light transmission can reduce its aesthetic appeal. This lampshade can be placed on the lamp to reduce light scatter, thereby enhancing its aesthetic appeal.

Plate four, indicated by the green arrow, is a color-changing circular piece installed inside the translucent hole. The color of the circular piece can be chosen independently. When the lighting is appropriate, the corresponding color will be visible through the translucent hole.