Search models, users, collections, and posts
Tyranid Exocrine
IP Report
Print Profile(2)
100%. 0.2mm layer, 2 walls, 10% infill
Designer
18.5 h
1 plate
125%. 0.2mm layer, 2 walls, 10% infill
Designer
26.2 h
2 plates
Open in Bambu Studio
Boost
276
943
8
6
205
42
Released
Description
Content has been automatically translated.
Another Tyranid model, in this case an Exocrine.
- This model is designed for display as it has no base, but it is easily adaptable to a generic base, and in this case, I have added holes in the legs to facilitate this.
- I have split the model to facilitate printing and minimize support material usage, so it requires a bit of superglue for assembly (this model is hollow, so it will print supports inside the halves, but it doesn't require infill which is a plus :) ). I recommend pressing the halves firmly against each other during drying to prevent a noticeable gap between them (I also used superglue accelerator).
- I have attached 2 print profiles: the first with the maximum size to print everything on a single A1 plate (100%), and another with the maximum size that one half fits on the A1 plate (125%, which totals 2 plates).
- The photos are of the 125% profile printed in eSun gray PLA, with no failures or breakages. The result is very good in my opinion.
I hope you like it :) Regards.
If you want to check out my other Tyranid models (before they get taken down, again) go to my profile or here https://makerworld.com/collections/27666936
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (8)