Search models, users, collections, and posts
Airsoft Mock Suppressor with Tracer Support-Short
IP Report
Print Profile(1)
0.16mm layer, 4 walls, 25% infill
Designer
2.5 h
1 plate
Open in Bambu Studio
Boost
1
12
0
0
8
5
Released
Description
If you are intrested in this, please check out my V2 design of this were I made both aesthetic and functional improvements.
https://makerworld.com/en/models/2813641-airsoft-tracer-suppressor-body-v2#profileId-3132198
Airsoft Mock Suppressor with support for tracers 28mm in diameter. Tracer used is Acetech Brighter R.
Tracer Base and Body included. Supports only needed on lower hole in base. Settings should make supports easy to remove.
Unit is 35mm in diameter and roughly 80mm length. The design of the base allows the inner barrel of the airsoft gun to stick into the base slightly before it gets to the tracer
Use at least PLA+.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)