Inferno Wyrm – Dragon Collection

Inferno Wyrm – Dragon Collection

The flames wrapping around the base give it that “emerging from fire” feel, and the head sculpt carries a ton of presence without needing a massive footprint. It’s one of those pieces where every angle hits a little differently, especially with the layered horns and scale work.

Up close, the detail really shows:

• Clean scale transitions across the neck and chest
• Deep, defined teeth and jaw structure
• Layered horn geometry that prints surprisingly well
• Flame base that adds motion without overcomplicating the print

Despite how complex it looks, it’s actually a pretty manageable print:

• Avoids excessive supports
• Details hold nicely even at smaller scales
• No assembly required — straight off the plate display piece

This is a strong addition to the Dragon Collection, especially if you’re going for variety — not just another dragon head, but something with a bit more energy and story behind it.
 

It’s got that “caught mid-roar” moment, like it just surfaced and everything around it is about to go very badly.

Supports: Cut below the mouth, remove large sections of supports. 
Then section across the mouth every 1cm and wiggle them free. Patience is key. 

All Model Print images are 100% real no AI !!!!!  What you see, is what you print! 

Please Post images of your prints!!!!!!!! 

Check out my profile for more super duper awesome models
Want to sell prints? Get a Commercial License here!