xTool P3 Air Assist Back Cover (No-Drill Upgrade)

If you’ve looked at adding a stronger air assist setup to your xTool P3, you already know the usual path… drill a hole and kiss your warranty goodbye.

This fixes that. I designed a clean, drop-in replacement back cover that lets you route upgraded air tubing without modifying your machine itself. No permanent changes. No awkward hacks. It looks like it belongs there.

What this does

• Adds a dedicated pass-through port for upgraded air assist tubing
• Keeps your original P3 housing intact
• Snaps into place using the existing design footprint
• Lets you run higher airflow setups for cleaner cuts and less charring

The important part (read this before installing)

• Installing this cover can void your warranty if the machine is inspected with it installed
• That said, this mod is fully reversible
• You can swap back to the stock cover in minutes and return the machine to its original state