Borderlands Handsome Jack & Lilith Chibi

Thank you all for your support. I'm always happy to hear your opinions and suggestions for new models. So please share them in the comments.

You can offer me a coffee and support my work here >>> https://ko-fi.com/drakeforge3d  If you like my work and want to support me, I appreciate any support. The website also includes a commercial license that allows you to sell all my existing models.

Handsome Jack & Lilith  Chibi

Bring a dose of Pandora’s madness to your shelf with this stylized chibi duo: a smug corporate tyrant and a fiery Siren, reimagined in a compact 90 mm format. These models capture exaggerated proportions—oversized heads, expressive eyes, and dynamic poses—while preserving the iconic attitude and silhouette that make them instantly recognizable.

The “Handsome” figure stands with confident arrogance, arm extended as if delivering another condescending monologue. Sharp hair, a fitted suit, and subtle mask details emphasize his cold charisma. Opposite him, the Siren radiates controlled power—poised stance, asymmetrical haircut, and a swirling energy motif in her hand, hinting at her destructive abilities beneath a calm exterior.

Both models are optimized for FDM printing and come pre-supported for easy slicing and reliable results. Fine surface details are balanced with print-friendly geometry, making them suitable for hobbyists who want strong visual impact without complicated setup. Clean separations, stable bases, and thoughtful support placement help minimize cleanup while preserving crisp features.

Perfect for collectors, painters, and fans of stylized figures, this set blends humor, menace, and attitude into two compact display pieces. Whether you paint them in classic colors or experiment with your own palette, these miniatures are ready to steal the spotlight—no Vault key required.

• Height: ~90 mm each
• Style: Chibi / stylized
• Format: FDM-optimized, with supports
• Recommended layer height: 0.12–0.2 mm
• Designed for easy printing and cleanup

     Guide

Each of my models is printed 2-3 times before releasing the profile. So if you have a problem with printing:

1. DRY THE FILAMENT
2. CHANGE THE NOZZLE TO A NEW ONE.

Recommendations  Guide : In case of a problem with damage to the supports, I recommend reducing the printing speed of the supports by 30-50% and the travel speed to 400mm/s. When removing the supports, I recommend first cutting off the pieces right next to the character, but not removing them, just cutting them off. Remove the remaining larger pieces and only then detach the remaining smaller pieces. This reduces the risk of damaging delicate elements.

• Please note that if you use a different filament than the recommended one, the effect may be different from my print. For example, printing in silk PLA will look better but the supports and the print itself will be more brittle and less durable.

   

   

  Recommendations:

• 
   
• 0.08-0.2. In the event of changing the original height, the height of the supports should be changed.
   

• PLA+HS, PLA+, PLA, PLA silk Recommended materials are listed in order from best to good.

   

• Clean the plate thoroughly before printing.
  Make sure the filament is dry and free from dirt. This can damage the print or weaken the support