Singer (Bolt Figure) for The Bänd!

Another figure for my bolt figure band!

Every band naturally needs singers too!

I present: Susi Singsang - the singer for The Bänd!

Also, a note here: there's a lot of support to remove. The rest is easy.
(What I can do, you can do too)

My miniature models of The Bänd! are based on the well-known bolt figures.
But here you don't need to be able to weld. Just fire up the 3D printer.

For the look in the photo:
Print (obviously), remove supports (oh dear…)
Prime (always with 3D printing)
Paint black with an airbrush (if necessary, with spray cans, but it always gets so thick)
And then Rub n Buff silver wax over it.
Apply as thinly as possible with a brush as a dry rub, then you get this metallic effect. Applied thickly, it will be uniformly silver.

The band is now playing in our living room.

The photos were taken with versions at 10cm height.
I've also tried 12cm (simply scaled up to 120%), which is also cool and easier to process.
150% also works, but it's too big for me - just try it out!

The Bänd! currently consists of 2 different guitarists, a singer, a drummer, and speakers.
Anything else desired? Just let me know.

Attention - before printing, check how large the parts should be:
10cm= 100% is standard, I've also printed some at 12cm = 120%. 150% was too big for me then.
These things should possibly also be printable well with SLA printers.

Due to the necessary support effort, only recommended for experienced 3D printer users.