X-17 Thunder Space Station
Print Profile(2)
Description
This is the 26th model I learned to make. Assembly needs glue~ (Always use glue in the final step)
Printing and assembling this requires courage and patience😂
It is about 50cm long and 42cm wide
Inspired by the Thunderhawk gunship from wargames~
A few points to note for assembly:
1: Perform a pre-assembly first, and always use glue at the very end!!
2: Pay attention to the connecting part between the fuselage and the engine. It has a slot at the very bottom that is easily overlooked. Please keep it facing backward!
3: Note the curvature of the landing gear and its connecting parts; they tilt outwards! Do not install them backward~
I made the last two mistakes simultaneously 🙃 It took me half a day to sand and reprint these parts! The process was painful~ I hope you don't make the same mistakes as me~🙃
This is a huge model. Don't glue it too early. Once a mistake occurs, the impact will be devastating! Trust me~😂
Also, the direction of the wings can be confusing because they can be inserted into the slots either way. Pay attention to distinguish~
I will remind you of these two issues again in the installation manual~
Otherwise, the installation went smoothly~ It might take up a day of your free time and a ton of glue~
Once again, remember not to glue too early!!!
Boost Me (for free)
Many thanks to every friend who boosted me, rated, gave feedback, and left comments! I might not be able to reply to each of you individually, but I want you to know that I am truly grateful!
Documentation (1)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (53)