Search models, users, collections, and posts
Pottery stamp blank
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 25% infill
Designer
34 min
1 plate
Open in Bambu Studio
Boost
49
248
1
1
122
55
Released
Bill of Materials
Bambu Filaments
Select all
.jpg)
Description
I do custom 3d modeling projects, reach out anytime!
pottery stamp blank you just have to put your extruded design on the head. Make sure to mirror your design so it is readable on its imprint. for lettering try to have it be at least .5 mm thick. And have your design be extruded .75mm high for optimal imprinting. the stamp has a notch in the handle for alignment so you don't have to look at the bottom of the stamp for orientation
Print settings
25% infill at least
enable top surface ironing
enable thin wall detection especially for lettering
i used pla tough and it turned out very well
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
Comment & Rating (1)