Kleiner MeshCore / Meshtastic Solar Repeater (#1)
Print Profile(1)
Description
Proven design for a small solar-powered MeshCore/Meshtastic repeater with sufficient space for the electronics. The XIAO nRF52840 & Wio-SX1262 Kit, an MPPT solar charge controller, and a 3000mAh Li-Po (103665) battery are recommended
The casing was primarily developed for mast mounting and is ideal for permanently operated outdoor nodes. Optionally, a spacer and a wall mount are available
Notes
- Printed with PETG
- It is best to print the casing and cover standing
- The solar panel and SMA connector were glued with 2K epoxy adhesive - 5-minute strong adhesive (Amazon)
Hardware Bill of Materials
- XIAO nRF52840 & Wio-SX1262 Kit (Seeedstudio)
- CN3791 Solar Charge Controller Board MPPT (Amazon)
- Solar Panel 17.3 x 12 cm (Aliexpress)
- Mini Slide Switch - 20 x 5.5 x 13 mm (L x W x H), Knob height: 5 mm (Amazon)
- JST 2 Pin Micro Connector / Sockets 1.25 mm (Amazon)
- 3.7V 3000mAh Lithium Battery 1S 1C LiPo Battery with Integrated Protection Board and Micro JST 1.25 Connector (Amazon)
- 868MHz LoRa Antenna + SMA Connector (Amazon)
- M2 Screw and compatible Heat-set insert
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including, but not limited to, publishing derivative works outside the Makerworld platform or hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money or collect fees. Subject to the above restrictions, derivative works may be published only within the Makerworld platform, and all such derivative works must be licensed under the same SDFL‑C license, without modification or additional terms. You may download the digital versions of this object, 3D print it, and display images, videos, or usage demonstrations of 3D printed versions of the object on personal social media platforms or Makerworld official channels, provided that no digital versions of the object are shared or distributed.
Comment & Rating (0)