Quad Lock Finger Ring Adjuster

PLEASE READ BEFORE PRINTING! THANK YOU

I designed this adjuster to make installing the model: https://makerworld.com/en/models/751546-ring-for-quad-lock#profileId-685314  by @ytk2 much easier. 

The adjuster allows you to turn the Quad Lock with less effort than using your fingers. If you were to try & turn it by the ring with the ring open it will likely snap off & it needs to be a tight fit. 

There are two sizes here, one for the standard ring designed by @ytk2

https://makerworld.com/en/models/751546-ring-for-quad-lock#profileId-685314

and one a bit larger to fit the profile uploaded by @tommigra

https://makerworld.com/en/models/751546-ring-for-quad-lock#profileId-1440205

There are other profiles available but I'm not sure if these will fit as I haven't needed to download them. 

*** I don't know if this adjuster fits the OG Quad Lock Ring made of metal as I don't have one. I doubt this would be needed for the OG ring as it's made of metal & should adjust without breaking.

The adjuster was printed in PLA but can be printed in whatever material you like.  I used PETG to print the model from @ytk2

Thank you for looking at my models & if you decide to print I hope you enjoy 🙂