Case for DJI Mini 3/4 Pro with attachment

During my drone outings, I realized how important it sometimes is, when potential shooting opportunities arise, to have the drone ready for use as quickly as possible. So instead of carrying the drone in a backpack or bag, I thought of making a case, still quite protective, that could be attached with an interlocking loop system to my trouser belt, thus leaving my hands relatively free.

I can confirm that it is very practical and lightweight, having tested it on several outings.

The drone, it is understood, has propeller guards and a transparent front shield installed for more than adequate protection.

In the attached images, you can see the male attachment fixed to the case with two screws that were inserted into two heated metal inserts, which I removed to simplify the production process. Now the case is printed in a single piece with the male interlocking part already fixed in place.

It could, I say, COULD, also be suitable for the Mini 5 Pro, but I do not own that model and cannot be certain, even if it seems to have the necessary capacity by eye. Please let me know in the comments if it fits.

After printing, you need to complete the hinge with a 2mm piece of metal wire and place a 4 x 6 cm adhesive mat rectangle of felt or rubber, approximately 3 mm thick, on the bottom of the case, to protect the drone's transparent front shield.

If you want to increase the drone's protection, as seen in the attached photos, you can place a piece of foam approximately 13-14 mm high on the inside of the flap, securing it with double-sided tape and adapting it accordingly, depending on the drone housed inside.