Starbucks Tap To Pay Wand

                                   If You want to sell my stuff please sign up for our Patreon HERE

This is the Starbucks themed Tap to Pay wand

More restaurants and like ones coming soon so check HERE to see what is out.

If you are going to use White. You need to make sure to use a white that is not mostly transparent (a lot are). 

Print both the heads, remove all of the supports. make sure you get all the little ones by the threads. 

Glue the two heads together. On these larger ones you can screw the stem on then put a dab of superglue at the two top corners, let that kick, then unscrew and squirt a little more in between them at the bottom. Or just put glue around the head and stick it together and get it aligned before it kicks

Glue the Cup lid on. This is a step you can do in a few ways. I checked the thread fit and made sure all was good on threading *see bellow. Then I glued the cup cap on first let that dry and then just pulled out the sides and did a little glue in there. Through the stem on real quick and everything is aligned great. I always suggest doing the two heads with slow glue. the cap you can do with a fast drying glue. Miss alignment is hard to do here and doesnt really matter.

Then slide your card in and screw the stem on, Hold it right below the threaded part. The first few times it can be stiff to screw on, it will get easier with time.

Then Go into that store or drive through like you belong there!