Jiang Dapao (Fake Erpao)
Print Profile(1)
Description
Because I could never buy a suitable Erpao
So I designed a fake Erpao
hahahaha
Its functionality is perfectly fine, and I will optimize and beautify it later.
Hardware list:
1. Cylinder 36-40 70mm
2. O-ring outer diameter 36mm wire diameter 3.5 2 pieces
3. Spring outer diameter 20-16mm is fine, wire diameter 1.6, 6-7cm
4. Pin 2mm thick, 16mm, 2 pieces; 35mm, 3 pieces (I used barbecue skewers)
5. Small spring 0.5*5*15
6. M3*10 screws 5 pieces
7. M3*30 4 pieces
8. M3*35 2 pieces
9. M3*25 2 pieces
10. Rubber pad 3mm, 30mm round
Special reminder: The holes inside are left relatively tight. If they don't fit, please enlarge the holes with a drill bit, or modify them by adding negative parts in the slicing software.
Be sure to use a new connecting rod for the swatter head.
Installation video is on Bilibili
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)