A1 extruder gear dust cover

Hello, I'm a designer in high school from belgium.

I make models in fusion and try to make as complex and bautiful models as possible.

I would really appreciate it if you would consider following me and giving me a boost.

Introduction:

When i was servicing my printer i saw that my extruder gear was covered in dust. And when you want to clean those gears you'l know that it's not easy to get to them so you better keep that dust out of there.

Thecnical aspects:

It fits every A1 i have not heared of a change to the print head of the A1 but if it dusn't fit let me know in the comments.

You should be able to use a self-printed front cover like i do in the picture.

Print settings:

Nothing special, if you have adhesion problems you could use a brim but is defenetly not needed.

Goal:

I want to give your A1 an upgrade both technically and aesthetically, so if it dusn't fit your A1 let me know, if you don't like the look let me know, if you had problems printing let me know.

Thanks for all your support and reading till the end of the discription!

Thanks for all the support and followers it's realy appreciated!