Small Coffee Cup Storage Pendant

A coffee cup pendant that can be used to store small items. The total height is about 7cm. The lid is designed with a slightly tight locking mechanism, so it won't come apart even with vigorous shaking. The hanging ring is installed at the mouth of the cup and can be removed if used as an ornament

(The lid of this pendant is not sealed and is only for storing small solid items. Do not use it for liquids to avoid spillage)

The pendant needs to be assembled by yourself after printing. Refer to the following GIF for demonstration

Assembly steps:

1. Use tweezers or a bed scraper to slowly pry up the support along the seam between the support and the main body. Clean the small support and residual shredded filament from the buckle at the mouth of the cup

(Many friends reported that the supports for the last macaron cable organizer were difficult to remove. This time, I have specifically optimized the bridging and support structure to make them easier to remove and to retain a flatter contact surface after support removal)

2. Insert the hanging ring into the lid opening from the bottom. You need to apply some force here to push the locking point in until the hanging ring is flush with the bottom of the lid. If it cannot be pressed in, you can try sanding the locking point of the hanging ring or flattening it slightly with a craft knife.

3. Put on the cup sleeve. This also requires some force. Perhaps I will need to optimize this structure later to make it easier to assemble, but for now, this is the only way. (I have also uploaded the profile for the version without a cup sleeve)

4. Align the lid and cup body with the buckle position, install, rotate the lid clockwise, and it will lock when you hear a click.