Search models, users, collections, and posts
Low profile twist box with rounded top
IP Report
Print Profile(1)
0.16mm layer, 3 walls, 15% infill
Designer
4.6 h
3 plates
Open in Bambu Studio
Boost
4
19
1
0
15
11
Released
Description
A threaded box with a rounded top.
It has a couple of special features:
- Three thread starts, meaning:
- It locks in just a third of a turn
- It can start closing in three different places, so it's super easy to use
- It has a rounded top
- Applies a daring overhang to the underside of the lid to achieve the beveled edge
Print notes
- Yes, the lid print orientation works reliably without a brim, but to be sure, clean your print bed.
- Tested on textured PEI and Coolplate Supertack (original)
- The overhang quality of the lid will be dependent on your filament. If you're unsure, use supports.
Also
- Yes, the lid would print better lying down with a chamfer instead of a brim.
- Yes, this design and printing method is definitely form over function (or at least form over strength and printing reliability)
- Yes, this way of printing does weaken the layer adhesion of the lid slightly, but not in a way that's meaningful for most applications.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)