Infinite Fury, Might of the Overlord - MWH

A new work of my original series —— ⌈MakerWorld Heroes⌋. 

The protagonist this time is Supernova, who rules the entire community and is extremely powerful.

This is the Infinite Fury set, which includes the Axe of Fury and the Shield of Fury.

• The axe is about 120cm long and 50cm wide.
• The shield is about 100cm tall and 60cm wide.
• Natively designed for printers with a 256 build volume.
• The Basic Axe and Basic Shield are the universal parts - you only need to print one copy of each. The other components can be swapped out using magnets.

About Print Profile:

• All pieces have passed the non-glued plate test.
• All profiles are pre-supported and can be printed directly.
• No obvious difference in appearance between PLA and PETG,  but I recommend PETG for better toughness.
• Ignore all the “non-manifold edges” errors and do not repair them. This is because I have separated the parts based on colors in the model. They will slightly overlap when exported, but this does not affect slicing or printing. Fixing them would make painting more difficult.
• The printing time and filaments consumption are shown in the diagram below (based on PETG):

About Assembly：

• Please refer to the attached assembly guide for installation instructions.
• The assembly of the Basic Axe and Basic Shield does not require screws or glue. However, different filaments will perform differently, if you find any loose spots, just use some glue to secure them.
• If you don't need the lighting effects, you can complete the four sets of appearances by simply purchasing some magnets. If you don't even want to install the magnets, you will need to use glue to attach the appearances.
• The table below is the parts list, the image contains a lot of information, if you can't see it clearly, you can download the high-res version from the attachment:

• Among these, only the battery and the belt need to be purchased from a third party, as Maker Supply hasn't listed them yet.
• The battery is the 3.7V 18650 + PH2.0 connector lithium battery from the sound-light kit. Maker Supply will have it available in Q4 2026. The same model can be found on Amazon.
• Any belt will work as long as its width is under 2.5 cm - just 2 ordinary belts.

My other works: