Search models, users, collections, and posts
Case feeder plate for .40 S&W by Whistler
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.3 h
1 plate
Open in Bambu Studio
Boost
1
3
0
0
0
0
Released
Description
This is my .40 S&W remix of AndrewRok's original case feeder plate for 9mm.
Works as intended.
I printed in PETG. PLA will probably work fine too.
Don't forget to add a small screw to the threaded hole to upset the cases into mixing and falling into the slots.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)