[Gelsoft] Arisaka Aimpoint Micro/ACRO mounts

This project is mostly for my enjoyment, any feedback is greatly appreciated, especially with the print configuration since I mostly created the model and commissioned someone else to print it, I have 0 other 3D printing knowledge.

-------------------------------------------------------------------------

2 red dot mounts made by Arisaka Defense, one for the Aimpoint Micro pattern sights, one for the Aimpoint ACRO pattern. Both mounts are tall enough to have 2.26" centerline height, so you can use them with flip-to-center magnifiers.

Hardware needed:

- Each mount only requires 1 M4x30mm or M4x35mm screw to be attached to a picatinny rail

- Insert the screw from the side of the small clamp piece. The screw is meant to be tightly lodged into the mount

This print is mostly for decorative purposes. Print in strong materials like PETG and with high infill if you have other uses for it. 

-------------------------------------------------------------------------

I have a list of prints, mostly dummy optics/optic risers/optic mounts, that I can't really afford to print. If you're interested in testing the prints and sending me showcase photos then feel free to contact me, all files will be free of charge:

• Trijicon MRO + Trijicon 3X Magnifier
• Aimpoint magnifiers with LaRue flip to side mount
• Aimpoint T2 red dot sight v2 (with lens caps that can be removed/rotated)
• ANVL UKON RMR mount for RMR pattern red dot sights
• Unity Tactical RAXIS for B.E Meyers MAWL laser
• Arisaka Low/2.26" Magnifier Mounts 
• Geissele 30mm scope mount
• ACR stock for A&K/DS/STS/AKA/JM gel blasters