[Gelsoft] KAC Skyscraper mount

This project is mostly for my enjoyment, any feedback is greatly appreciated, especially with the print configuration since I mostly created the model and commissioned someone else to print it, I have 0 other 3D printing knowledge.

-------------------------------------------------------------------------

A red dot mount/riser made for the Aimpoint Micro pattern sights, to be paired with magnifiers

The files contain 2 mounts, 1 at 2.33" centerline height like the real mount, the other at 2.26" centerline height, so you can use them with flip-to-center magnifiers and use the picatinny section for laser devices. Both mounts use the same clamps

Hardware needed:

- Each mount only requires 2 M4x30mm screws to be attached to a picatinny rail

- Insert the screw from the side of the small clamp piece. The screw is meant to be tightly lodged into the mount

This print is mostly for decorative purposes. Print in strong materials like PETG and with high infill if you have other uses for it. 

-------------------------------------------------------------------------

I have a list of prints, mostly dummy optics/optic risers/optic mounts, that I can't really afford to print. If you're interested in testing the prints and sending me showcase photos then feel free to contact me, all files will be free of charge:

• Trijicon MRO + Trijicon 3X Magnifier
• Aimpoint magnifiers with LaRue flip to side mount
• Aimpoint T2 red dot sight v2 (with lens caps that can be removed/rotated)
• ANVL UKON RMR mount for RMR pattern red dot sights
• Unity Tactical RAXIS for B.E Meyers MAWL laser
• Arisaka Low/2.26" Magnifier Mounts 
• Geissele 30mm scope mount
• ACR stock for A&K/DS/STS/AKA/JM gel blasters