Truma Heater Air Vent with Extension
Print Profile(1)
Description
I designed this air vent because the vent in my rear garage was covered by a box. For this air vent, I then designed suitable extensions, one with a spacer, and one without
These can be stacked into each other as many times as desired, possibly fixed with a little glue. The model should be printed with at least PETG
The model can be printed without supports, in which case it is recommended to reduce the overhang speed
I used these settings
0 mm/s at 10%
20 mm/s at 25%
20 mm/s at 50%
10 mm/s at 75%
10 mm/s at 100%
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including, but not limited to, publishing derivative works outside the Makerworld platform or hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money or collect fees. Subject to the above restrictions, derivative works may be published only within the Makerworld platform, and all such derivative works must be licensed under the same SDFL‑C license, without modification or additional terms. You may download the digital versions of this object, 3D print it, and display images, videos, or usage demonstrations of 3D printed versions of the object on personal social media platforms or Makerworld official channels, provided that no digital versions of the object are shared or distributed.
Comment & Rating (1)