Print Profile(2)
Description
Recreated Coco Bakery's little light box
Perfect for concert banter material
The touch light component used is this one
Installation is very simple, notes
1. The component must be snapped into place. Before sealing, charge it first to check if the circuit board is snapped into the correct position, to prevent it from becoming loose and unable to charge after sealing
2. Just glue it firmly with 3D printing glue
3. There are 4 magnet slots; you can use 8mm/7.5mm diameter magnets
No commercial use, no group buys. All uses are prohibited except for personal use and friendly banter
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)