Pirate's Cove - Legos baseplate A1 mini (22x22)

Are you a fan of the classic 90s Pirates era? This custom 3D-printable baseplate is heavily inspired by the iconic 6265 Lagoon Lock-up and the golden age of Pirates Legos sets.

I designed this 22x22 stud island to give your Imperial Guards or Pirate crews a proper home. It features a clean transition from the deep blue sea to a sandy beach, either just adding a pause, or using the AMS.

NOTE:  this is the A1 mini version, there is a slightly bigger A1/P**/H** version here. This one is mostly the same (same shape, same brick compatibility) but fits perfectly the A1 mini size restrictions.

Every single stud is perfectly aligned on the standard brick grid. Whether on the sea level or the island plateau, your bricks will always snap on straight! This model is 24x24 studs (192x192mm). It's large enough for a full building but optimized to save filament (only 5% infill required).
 

Modular Potential: This is the first island of a planned archipelago.

Important: Fitting & Tolerances (XY Expansion)
 

Every printer and filament brand (PLA, Matte, Silk) reacts differently. If your bricks are too hard to snap on or, conversely, too loose:

• Too Tight? Go to the "Quality" tab in Bambu Studio and set "XY Contour Expansion" to a small negative value (e.g., -0.05mm or -0.1mm).
• Too Loose? Set "XY Contour Expansion" to a small positive value (e.g., +0.05mm).

In doubt, you can test it first with my Brick Stud Calibration "Clutch Power" test