Print Profile(0)
Description
A practical drip coffee stand, foldable, easy to carry and store. It can flexibly fit cup openings with a diameter of 50mm-90mm (suitable for most common cups)
The red insert buckle: pull down to lock the support, pull up to retract for folding.
PS: To avoid the bottom edge being too sharp, it has been rounded. If there are a few strings during printing, it's fine; just trim them off and lightly sand after printing.
The entire design has been adjusted multiple times and verified through multiple prints. There are no issues, so feel free to print.
Assembly:
1) Face the bracket slot outwards towards the rim, and insert the bottom shaft into the plate's axle hole
2) Take the red insert, with the tab side facing outwards towards the rim, and insert it into the bracket slot.
Boost Me (for free)
If you like this model and want to support me, this will be my motivation to continue 3D modeling and designing~
License
Comment & Rating (0)