RC crawler tire liner open source version can pull a camping car
Print Profile(1)
Description
Are you tired of foam liners going soft after a few uses? Print this hub, and it will immediately firm up!
This size is only for 1/8 scale tires, and I installed it on an MJX H8H.
I printed it with PETG; theoretically, TPU could also work, but I haven't tried it yet. PETG met my requirements.
It's best to print with PETG.
It's a very simple tire liner with three cylinders inside: one is the main body, one is the inner diameter, and one is the modifier.
By scaling the main cylinder body, you can print different sizes of tire liners according to your desired tire size.
As long as you change the main body size, you must also change the modifier to the same size. The Z-axis height can be a bit higher,
adjust the inner diameter to fit different hub sizes.
You can also post your tire dimensions in the comment section, and I will upload different profiles.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including, but not limited to, publishing derivative works outside the Makerworld platform or hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money or collect fees. Subject to the above restrictions, derivative works may be published only within the Makerworld platform, and all such derivative works must be licensed under the same SDFL‑C license, without modification or additional terms. You may download the digital versions of this object, 3D print it, and display images, videos, or usage demonstrations of 3D printed versions of the object on personal social media platforms or Makerworld official channels, provided that no digital versions of the object are shared or distributed.
Comment & Rating (0)