5-inch FPV Drone Powered Airboat
Print Profile(1)
Description
This is an RC shrimp boat powered by a 5-inch FPV drone motor. It's not very fast. To solve the propeller splashing issue, 3 versions were successively modified. The current version basically doesn't splash after planing, but it still splashes during sharp turns and acceleration from a standstill, though this impact is now minimal.
Hardware
2mm self-tapping screws, both 6mm and 8mm long, will work. The total number will not exceed 50, so buying two packs directly from a hardware store will definitely be enough.
Two 2mm shafts, 110mm long, for the two air rudders, and one 60mm shaft for the water rudder.
Electronics:
One 9g servo, try to use a waterproof one. Alternatively, you can waterproof the circuit board yourself with 704 sealant and then seal the gearbox output shaft with grease.
2306 2300kv motor, 35A bidirectional ESC
3-channel receiver
1550mAh 4S battery
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (12)