Search models, users, collections, and posts
Ryobi IntelliPort Charger Holder for Multiboard
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
24 min
1 plate
Open in Bambu Studio
Boost
0
1
0
0
2
1
Released
Description
Ryobi IntelliPort Charger Holder for Multiboard to be mounted on the wall.
The spacing for the knobs are 63mm.
To be screwed on the Multiboard. Print sideways for maximum strength
Because of license terms I didn't include these screws in the design. You may find those from the following link:
You need 2 pcs of 9 mm Small Thread, Flat Head, Shank T-Bolt
Heavily inspired by this but modeling all done by myself!
https://makerworld.com/en/models/2819708-ryobi-charger-holder-multiboard#profileId-3139991
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)